Technical training
Blade Repair Standard / V5 23022026
The participants shall:
Practise the ability to:
a. apply filler to a laminate repair on the leading edge and to shape the filler to match the surrounding aerodynamic profile of the leading edge
b. shape the cured filler with a sander so that it accurately matches the surrounding aerodynamic profile of the leading edge and has the correct surface finish for the adhesion of paint
c. apply the knowledge gained in Lesson 21 (Painting) by applying two-factor component paint to repairs using a roller
SANDWICH PANEL REPAIR
180 min.
The aim of the lesson is to enable the participants to carry out laminate repairs on the inner and outer laminate of a sandwich panel safely and effectively.
The participants should always refer to the safety data sheets, technical data sheets, work instructions and relevant applicable legislation throughout the duration of the repair conducted in this lesson
Note
The participants should always perform correct segregation and disposal of waste produced during this lesson
Note
After having successfully completed this lesson of the Blade Repair Module, the participants can:
289) Take responsibility for carrying out laminate repairs on the inner and outer laminate of a sandwich panel safely and effectively (Ability, intermediate level)
ELEMENT 31.1 - MINIMISE RISKS ASSOCIATED WITH COMPOSITE FIBRE WORK
Learning objective:
290) The participants can act independently in applying the knowledge gained during the general safety lessons to the working environment to minimise the risks associated with composite repair work (Ability, intermediate level)
Global Wind Organisation / www.globalwindsafety.org
140 / 187
Made with FlippingBook flipbook maker