Technical training
Blade Repair Standard / V5 23022026
BASIC LAMINATION
290 min.
The aim of the lesson is to enable the participants to produce two, 2–3-layer flat laminate panels safely and in accordance with a work instruction.
After having successfully completed this lesson of the Blade Repair Module, the participants can:
164) Take responsibility for producing two, 2–3-layer flat laminate panels safely and in accordance with a work instruction (Ability, intermediate level)
The participants should always refer to the safety data sheets, technical data sheets, work instructions and relevant applicable legislation throughout the duration of the repair conducted in this lesson
Note
The participants should always perform correct segregation and disposal of waste produced during this lesson
Note
ELEMENT 19.1 - MINIMISE RISKS ASSOCIATED WITH COMPOSITE FIBRE WORK
Learning objective:
165) The participants can act independently in applying the knowledge gained during the general safety topic to the working environment to minimise the risks associated with composite repair work (Ability, intermediate level)
The instructor shall:
Explain the safety precautions and personal protective equipment requirements for working in the workshop area (Recap from general safety)
Continually assess and give feedback on the participants’ ability to apply the knowledge gained during the general safety lessons to the working environment to mitigate the risks associated with composite repair work
The participants shall:
Practise the ability to apply the knowledge gained during the general safety and chemical safety lessons to their working environment by correctly selecting and using PPE appropriate to the task in hand based on the safety data sheet, work instruction, and any other relevant document related to
Global Wind Organisation / www.globalwindsafety.org
87 / 187
Made with FlippingBook flipbook maker