Technical training
Blade Repair Standard / V5 23022026
b. correctly calculate the required amount of matrix material required for the given amounts of reinforcement material
c. correctly calculate, measure out and mix the separate components of the matrix material
d. apply the first layer of fibreglass and matrix material focusing on the fibre straightness, wetting out the fibres and removing air from the matrix using a bolt roller. Repeat with the second layer of fibreglass
e. apply peel ply to the laminate and place the thermocouple, and how to cover the laminate with vacuum film to protect the heating blanket from resin
f. place the heating blanket without folds, and how to adjust the temperature of the heating blanket in accordance with the temperature reading from the thermocouple to the required curing temperature in accordance with an approved work instruction or the matrix technical data sheet
g.
determine the required curing time
Explain that the curing time starts when the matrix material has reached the required curing temperature
After the curing time, demonstrate how to safely remove the heating blanket and, place it to cool down
Demonstrate how to safely remove the vacuum film and peel ply, and measure the hardness of the cured laminate with a Barcol/Shore D tester
Give constructive feedback on the participants’ above practice and explanations
The participants shall:
Practise the ability to:
a. prepare a flat aluminium mould surface with release agent, allow sufficient time for the release agent to dry, and mark out the required area with flash tape
b. accurately measure out and mix the required quantities of each component of gelcoat. Apply the gelcoat evenly and at the correct layer thickness in accordance with a work instruction
c. accurately measure and cut the required pieces of glass fibre. Mark the zero direction of the roll on the cut pieces
d. accurately measure out and correctly mix the required quantities of each component of the matrix material in accordance with an approved work instruction
e. consolidate and remove air using a bolt roller and to keep the fibres as straight as possible
Global Wind Organisation / www.globalwindsafety.org
89 / 187
Made with FlippingBook flipbook maker