Technical training
Basic Technical Training Standard / V11 10032026
5.4 Duration of the Basic Technical Training Standard Modules The contact time for completing each module of the Basic Technical Training Module as a standalone training is indicated in table 5.4.1 below. This is based on the times given in the module timetables.
The training provider must not exceed the time per day given in table 5.4.2 below.
BTT modules allow for slightly reduced overall timings when delivered in combination to the same participants due to complimentary topics covered across different modules. Refer to tables 5.4.3, 5.4.4, 5.4.5 and 5.4.6 for details.
Note
Modules
Duration as standalone training
Mechanical
10 hours 30 minutes
Electrical
10 hours 5 minutes
Hydraulic
9 hours 15 minutes
Bolt tightening
9 hours 0 minutes
Installation Mechanical
8 hours 00 minutes
Installation Electrical
12 hours 25 minutes
Hazardous Energies Basic Safety
4 hours
Table 5.4.1 - Duration of GWO BTT Modules as standalone training delivery
Maximum Duration Per Day
Contact time
8 hours
Total training day
10 hours
Table 5.4.2 - Maximum duration for training days
Contact time includes delivery of course lesson content, practical exercises and activities directly related to these.
Note
The total training day includes contact time, meals and breaks and travel between training sites (where applicable).
Global Wind Organisation / www.globalwindsafety.org
21 / 396
Made with FlippingBook - PDF hosting