Technical training
Basic Technical Training Standard / V11 10032026
The participants shall:
Practice cutting and crimping small signal cables:
a.
shielded and unshielded
b.
rubber and PVC insulation types
c. install heat/cold shrink tube on top of cable and cable lug after cable lug has been crimped
Practice cutting and crimping main power (LV) cables:
a. copper and aluminium (special attention to the correct cable die-set)
b.
rubber and PVC insulation types
ELEMENT 8.7 - MARKING, ROUTING AND TERMINATION OF ALL CABLE TYPES
Learning objectives:
72) The participants can describe typical faults during termination, and ways to mitigate these typical faults (Knowledge, basic level)
73) The participants can perform the marking, routing and termination of all cable types (Skills, intermediate level)
The instructor shall:
Show examples of and explain different types of marking and their purposes for all cable types:
a.
cable and conductor
b.
cabinet (diagram)
Show examples of and explain important factors when routing all cable types (inform participants to refer to work instructions for the specifics):
a.
bending radius (why a minimum is important)
b.
not twisted
c.
distance between cable types and groups
Global Wind Organisation / www.globalwindsafety.org
279 / 396
Made with FlippingBook - PDF hosting