Technical training
Basic Technical Training Standard / V11 10032026
•
Cable ties
•
Heat shrinks / cold shrinks
•
Hexagon (Allen) keys
• Tool set for cutting, stripping and crimping small cables (smaller than 6mm2) – 1 set for 2 participants • Tool set for cutting and stripping main cables (massive & core conductors, bigger than 35mm2) – 1 set for 2 participants • Tool set for crimping wires bigger than 35mm2 (electric or electro-hydraulic) – 1 set for 4 participants • Log Out Tag Out kit (this kit should not be required if not needed considering the setup available for the practical exercises)
•
Mock-up for cable work including:
• Electrical cabinets with standard DIN rails for mounting terminals (clamp, screw type)
•
Clamp, screw type terminals
•
Cable glands
•
Cable trays
•
Bus bars (copper) with holes to connect cables with cable lugs
Any equipment used during this GWO training module shall meet or exceed the minimum requirements of the national standards in the country where the training is taking place. When working in a country where there is no applicable national standard then the equipment shall meet or exceed the minimum requirements of the European standards.
6. Equipment list: Hazardous Energies Basic Safety Module
The following equipment is required during the entire duration of this training to meet the needs of the BTT Hazardous Energies Basic Safety Module:
• Three kits of basic PPE (gloves, safety goggles, safety shoes or boots and working clothing)
•
Lockout-Tagout equipment. As a minimum:
o 3 x padlocks o 3 x caution notices / tags
Global Wind Organisation / www.globalwindsafety.org
342 / 396
Made with FlippingBook - PDF hosting