Technical training
Basic Technical Training Standard / V11 10032026
Annex 2 GWO Manual for Bolt Torquing (For Training Purposed Only)
• Introduction. Safety. Sentence added “If no safety handle is present do not perform operation.”
BTT Hydraulic Module
Element 10.2
• Changed element name to: “Element 10.2 - Collecting Oil and Grease sample”.
Added text to 10.2.1: “or grease sample”.
•
Added text to 10.2.2: “or grease sample”.
•
Added text to 10.2.3: “or grease sample”.
•
• Added point 10.2.4: “Facilitate discussions about oil and grease cleanliness”.
Added text to 10.2.5: “or grease sample”.
Amendment date
Version
Approved by & date
May 2023
8
GWO TC May 2023
Description of changes
Changes throughout:
New layout
•
• GWO Requirements for Training – title updated Safety lessons:
• Three safety lessons previously found in BTT V6 in the BTT Mechanical, Electrical and Hydraulic modules (Mechanical Safety, Electrical Safety and Hydraulic safety) have been re-added, with an exemption clause for participants who have completed the GWO CoHE training. • Duration instructions and timetables updated for all modules to align with the GWO Requirements for Training Section 4 Scope:
Revised and updated
•
Section 5 General requirements for GWO training:
Bolt tightening added
•
• Medical requirements, WINDA ID, physical demands etc. removed as this is covered by the GWO Requirements for Training.
• Aim adjusted to include bolt tightening and company specific training
• Times adjusted to accommodate the new Bolt Tightening module
Global Wind Organisation / www.globalwindsafety.org
388 / 396
Made with FlippingBook - PDF hosting