Operations Manual
WITS Cable and Setup D-Tech has developed a custom WITS cable ( Figure 6 ) to transmit data from the WITS feed source to the WITS decoder, see image below, this can be used to also split/share the WITS feed with another PC. If the WITS feed is to be shared, then the red switch on the splitter box should be in the ON position.
Figure 6
WITS Decoder Software Setup 1. Open the WITS decoder on the Windows PC. 2. Select the communication tab and verify that the USB port is connected to the WITS feed on location. 3. Select the appropriate com port number and click ‘Open’ under step 1 on the screen. 4. Select the ‘write frequency’ to 10 seconds. This will not affect the operation of the program at the rig site. 5. On the right side of the window check the box ‘Show Wits Feed‘ a. Data will begin to scroll in the open area on the right. IF DATA IS NOT DISPLAYED CONTACT D-TECH SUPPORT BEFORE MOVING FORWARD.
OPS-FIELD-001 | Rev. H
dtechdrilling.com | 22
Made with FlippingBook Digital Publishing Software