SCH80 Industrial C-PVC
More than 90% of pipe joint failures evaluated are due to improper preparation of pipe end.
Cut Pipe Clean and Square A 10-15 deg chamfer is required This enables correct seating of pipe into fitting
The strongest bond is the fused surface where the pipe & fitting meets at the end. When chamfering and the cut is correct, the pipe will seat at the bottom of the fitting.
1. The jointing surfaces must be softened and made semi fluid
2. Sufficient solvent cement must be applied to fill the gap between the pipe and fitting.
4. Joint strength develops as the solvents escape from the joint.
3. Assembly of the pipe and fitting must be made while the surfaces are wet and the solvent cement is still fluid.
Installation Accessories: Please see page 284-285 for a complete list of brushes and installation accessories.
IPS Weld on Cement 473ml
IPS Weld on Cement 946ml
IPS Weld on Primer 473ml
IPS Weld on Primer 946ml
Deburring Tool 1/2” - 1”
Deburring Tool 1-1/4” - 2”
1300 PIPING (1300 747 464)
PAAS Source Book 51
Made with FlippingBook - Online catalogs