TOOLS & PIT EQUIPMENT
Ride Height Set-Up Stick ALL10658 Stick replaces the coil-over shock and spring
Toe Plates Aluminum plates simplify setting of toe-in and toe-out. 3ODWHV¿WDJDLQVWRXWVLGHHGJ - es of tires. Using two tape measures (sold separately), measure the distance front and rear, between plates. The difference in tape readings is the toe setting. Deluxe plates have radiused edges, slots for narrow and wide tape
assembly during maintenance. Stick has many uses and may be adjusted to check settings at normal ride height, in race attitude, or on the bump stops to eval-
ALL10117
uate suspension travel. Adjusts from 15" to 24", measured at the center of rod ends. Set-Up Tool ALL10668 Tool replaces the front coil-over shock assembly to simulate range of front suspension movement for checking bump steer and roll center. Hex-head threaded shaft raises and lowers suspension to simulate racing conditions. Jam nuts can be positioned to limit rebound and compression. Not designed to support total vehicle weight, only suspen- sion components. Set-Up Plates
ALL10119
measures and are 9" tall x 23" wide to work with vehicles with smaller wheel openings. Standard plates are 1/2" thick, 11" tall x 32" wide and work well for vehicles with larger wheels and wheel openings. Set of two plates. Part No. Description ALL10117 Standard ALL10119 Deluxe 16' Tape Measure ALL10675
16' x 3/4" blade has fractional markings every 1/8" for quick reference. Caster Kit Measure your front end caster by attach- ing an adapter and level holder to your upper ball joint threads. Additional adapt- ers may be purchased separately for other use. Digital level sold separately. Part No. Description ALL11162 Kit with Holder, BJ Adapters and Carry Case (No Digital Level) ALL11164 Holder Only for Digital Level ALL11165 Quickchange Pinion Angle Adapters (2) ALL11166 Late Model Spindle Adapter ALL10742 2x2 Digital Level Caster Plate ALL10752 Not sure if you turned your wheels the same amount each time when adjusting caster settings on your race car? Unless you have expensive turn plates, you’re never certain, until now. This quick-reference gauge positions
ALL10660
ALL10662
Set-up plates are used for squaring and stringing chassis to ensure accurate chassis set-up by eliminating wheel and tire differences. Plates are 1/2" thick and can also be used when setting bump steer or checking axle tubes for straightness. Sold each. Part No. Description ALL10660 5x5, 7" x 28" ALL10662 Wide 5, 12" x 28" Upper Ball Joint Wrench ALL11190 Wrench is designed to remove and install common screw-in upper ball joints that are 1.900" wide (ALL56214). Bolt Center Caps ALL10678
under the upper ball joint nut, with markings facing up, for easy viewing. Place a mark on the shock body or fabricate an indica- tor to use as a reference point. Ground Clearance Indicator ALL10725
Determine how close the frame is to the ground on the race track. This unique kit features an aluminum bracket that rivets to the frame with an adjustable 4" plastic wear rod. Replacement Part Part No. Description ALL10726 Wear Rods, 4-Pack
Caps slip over the head of standard 1/2" bolts to accurately measure the center-to-center length of installed sus- pension tube assemblies. Machined step
secures the end of a standard tape measure for easy reading of the length to the center of the opposite cap. Caps feature a built-in O-ring that allows the cap to swivel on the bolt head and keeps it from falling off. Package of 2.
161
CIRCLE TRACK 2021-22
Made with FlippingBook flipbook maker