Integrally Heated Hot Sprue Bushings
94
Integrally Heated Sprue Bushings .750" SERIES
Operating & Servicing Instructions The Integrally Heated Sprue Bushing bodies are identical in design, but differ in length and head style. All Sprue Bushings feature an integrated heater; Type “J” thermocouple; 60” wrapped - 600 volt leads; right angle lead exit; and 6” stainless
steel, square-lock armored cable. Start-Up/Operating Procedures
If the temperature controller does not utilize “soft start” technology, set the controller to 200°F (93.3°C) in automatic mode or 10% in manual mode. Allow bushing to “soak” for 15 minutes before increasing to processing temperature. This step will allow the unit to dissipate potential moisture and prolong heater life. Power Requirements • 240 Volts AC – 15 amp fuse • Grounding – Integrally Heated Bushings utilize the direct contact of the bushing, mold plates, and machine platens to establish a path for grounding.
*WARNING* There must be a ground
present between the mold “hot half” and the temperature control system or damage may occur to the bushing, thermocouple
and/or temperature control system.
Maximum heat 600ºF
1.135 (28.8mm) 1.135 (28.8mm)
Locating Ring Dimensions
5/16 - 18 THD Jack Screw location (2 places) 5/16 - 18 THD Jack Screw location (2 places)
ITEM NUMBER
L.R.D.
3.990” (101.3mm)
ML010012
5.490 dia. (139.4mm) 5.490 dia. (139.4mm)
3.990" dia (101.3mm) 3.990" dia (101.3mm)
For 5/16 - 18 SHCS (2 places) For 5/16 - 18 SHCS (2 places)
1.625 R (41.3mm) 1.625 R (41.3mm)
.510 (12.9mm) .510 (12.9mm)
Customer to machine counterbore. Customer to machine counterbore.
Machining Options for Keying
.83 R min.* (21.1mm) .83 R min.* (21.1mm)
.75 R min. (19.1mm) .75 R min. (19.1mm)
Dowel Pin Dowel Pin
Socket Head CapScrew Socket Head Cap Screw
*Centerline for #10 Screw Dimensions are in inches; millimeters are in parentheses.
U.S. 800-626-6653 n Canada 800-387-6600 n dme.net n store.dme.net
Made with FlippingBook - professional solution for displaying marketing and sales documents online