Sheet 4085 Page 5
"H" AND "W" TYPE BOOT AND SNAP-LOCK REPLACEMENT INSTRUCTIONS
Snap-lock R360-5055
½ "
"H" Boot R360-5054
1. Strip 5⁄8 " insulation off wire 2. Bend wire back as shown above 3. Crimp snap-lock on insulation 4. Insert snap-lock into boot as shown
"W" Boot R360-5052
"N" AND "S" TYPE BOOT AND SNAP-LOCK REPLACEMENT INSTRUCTIONS
½ "
"N" Boot R840-5821
"S" Boot R840-55231
Screwdriver
1. Strip ½ " insulation off wire 2. Insert wire into boot as shown above 3. Secure clip with slotted screwdriver (clockwise to tighten)
"C" TYPE ¼ " Ø SNAP-LOCK IGNITION TRANSFORMER CLIP REPLACEMENT INSTRUCTIONS
1. Strip 5⁄8 " insulation off wire 2. Bend wire back ½ " as shown
½ "
3. Crimp snap-lock clip on insulation, as shown 4. Heat shrink plastic sleeve over clip and wire
Plastic Sleeve 4-10129-1
Ignition Transformer Clip R840-4998
WARNING: Situations dangerous to personnel and property may exist with the operation and maintenance of any combustion equipment. The presence of fuels, oxidants, hot and cold combustion products, hot surfaces, electrical power in control and ignition circuits, etc., are inherent with any combustion application. Components in combustion systems may exceed 160°F (71°C) surface temperatures and present hot surface contact hazard. Fives North American Combustion, Inc. suggests the use of combustion systems that are in compliance with all Safety Codes, Standards, Regulations and Directives; and care in operation.
CONTACT fna.sales@fivesgroup.com T +1 800 626 3477 - F +1 216 373 4237
Fives North American Combustion, Inc. 4455 East 71st Street - Cleveland, OH 44105 - USA www.fivesgroup.com
Made with FlippingBook flipbook maker