Combustion Catalog | Fives North American

Ignition & Flame Supervision | Premix Gas Burner Nozzles

INSTALLATION

IGNITION AND FLAME SUPERVISION

When piping 4682 nozzles to aspirator mixers, for best opera- tion, use at least 4 pipe diameters between nozzle and near- est fitting or mixer. For additional information see: Handbook Supplement 14 “Straight Pipe Run Requirements.“ If these guidelines are not followed the burner may not be stable at the maximum firing rates and/or the ratio limit range my not be as wide.

Although it is common for 4682 burners (especially in spot heat- ing applications) to be manually torch lit, there are direct spark ignition and pilot options for lighting them. 4682 burner nozzles are available with an optional 10 mm spark plug port as the 4682-#T/BO for use with a direct spark ignition system. See page 5 for ordering instructions. Note: the spark plug port is not accessible when the nozzle is used in a mounting plate or air register.

R240-2465 10 mm spark plug (order separately)

5 L/D (Min)

Mixer

Burner

5 L/D (Min) Burner

4682-#T/BO Burner Nozzle (non-"T" 4682 nozzles do not have the connection for spark plug

Mixer

Burner

4 L/D (Min)

Optional mounting plates (MP) and air registers (AR) are available that facilitate proper positioning of premix pilots and UV flame detectors. They also help assure alignment of nozzle with firing tunnel in furnace wall. For 4682-0 through -7 sizes, order mount- ings and/or tiles as separate items. 4682-8 and -9 Burners can be ordered as separate pieces -- nozzle, air register (with shutter to control secondary air), tile mounting plate.

The preferred location for pilot tips (and UV cells) is on the top or side of a burner so that scale, dirt, and refractory crumbs cannot fall into it.

ADDITIONAL REFERENCES

These Fives North American Combustion bulletins, sheets and guides may be helpful when designing, installing and operating combustion systems with 4682 burner nozzles:

Flame supervision can be accommodated with a combo flame rod igniter with the 4682 sizes -1 through -6.

— 3070 High Pressure Inspirators — 3065 North American Aspirator Air/Gas Mixers — 4011/4021 4011 Pilot Sets/ 4021 Pilot Tips

Electrode Tip

— 4696 Gas-Compressed Air Torches — 4065/4066 Ignition Transformers — 4085 Ignition Cable — 7218 Air/Gas Ratio Regulators

4682-CFI Assemblies with combo flame rod/igniter

— 8800-1 Ultraviolet Flame Detectors — 8800-2 Flame Rod/Flame Detectors — 8832 Flame Detector Adapters - 8832 through 8838 — North American Combustion Practical Pointers

Besides the CFI assemblies, using flame rods in 4682 burners is very difficult. Fives North American does not have other options for using flame rods with 4682 burners.

Bulletin 4682 Page 3

Made with FlippingBook flipbook maker