ABB - FREE@HOME® MAK ING HOME AUTOMAT ION E AS I ER THAN EVER
40
Now easier than ever. Only a few components are needed to install ABB-free@home®. For the direct activation of light, the entire system only requires a bus cable, the sensor/actuator unit, a power supply and a System Access Point for programming. — Simply effortless This saves valuable labour time
— 01 System Access Point — 02 Sensor, 1gang — 03 Switch actuator, 4gang — 04 Binary input, 2gang, flush-mounted — 05 Power supply
— 01
The System Access Point The nerve centre of the ABB-free@home® system is the System Access Point. It provides access for computer, tablet or smartphone via WLAN. This allows the functions of the system to be defined and remotely controlled – even after installation. The System Access Point can also be combined with a network router – via LAN or WLAN. Just connect and you’re done. For convenience, the System Access Point cre- ates its own WLAN and the software necessary for project planning and commissioning is already on board. This makes you independent from the structural conditions and no addi- tional software is required. As soon as you are finished with programming you can save the status and restore it again at any time.
— 02
— 03
— 04
— 05
The actuators and sensors Actuators for switching, dimming and control are available for ABB-free@home®. The flush-mounted binary inputs also allow the integration of conventional switches and devices, such as window contacts, for example. Push-buttons, room temperature controllers and movement detectors are avail- able as sensors.
Made with FlippingBook - Online magazine maker