Solar Manager Pro Accessories
Accessories to manage the solar system
Code
DATALOGGER DL3 PRO With the DL3 Pro you can easily and conveniently log system data of up to 6 controllers get a comprehensive overview of all controllers connected with the large full graphic display. Transfer data with an SD memory card, or use the LAN interface to view and process data on your PC. DATALOGGER DL2 PRO This module enables the acquisition and storage of large amounts of data (such as measuring and balance values of the solar system) over a long period of time. System access is possible with just a few clicks via VBus.net For transmission of the data stored in the internal memory of the DL2 to a PC, an SD card can be used. The extension Module provides 5 additional relays and 6 additional sensor inputs. Up to 3 extension modules can be connected to the Solar Manager Pro via VBus®. The Extension Modules themselves do not require any adjustments, they are simply connected and assigned to the controller. The inputs and outputs of the registered modules will then be available for all functions of the controller. IRRADIATION SENSOR PRO The solar cell is used for measuring the irradiation intensity. The short-circuit current rises with increasing irradiation intensity. The sensor can also be used for additional functions. The connecting cable can be extended to 100 m. RPD SENSOR PRO Measure the temperature and the relative pressure with a single measuring element and then transmit the measured values directly. They can be optimally used for leakage and overpressure monitoring. Can be used in aggressive media as well as in domestic water and thus are ideal for the application in solar thermal and heating systems. VFD SENSOR PRO SMALL The digital sensor measure the temperature and the flow rate with a single measuring Can be used in aggressive media as well as in domestic water and thus are ideal for measuring the flow rate and the heat quantity in solar thermal and heating systems. VFD Pro Small has an operative flow range 1-12l / 25-80°C MaxT 100°C (120°C short). VFD SENSOR PRO BIG The digital sensor measure the temperature and the flow rate with a single measuring Can be used in aggressive media as well as in domestic water and thus are ideal for measuring the flow rate and the heat quantity in solar thermal and heating systems. VFD Pro big has an operative flow range 2-40l/ 25-80°C MaxT 100°C (120°C short).
3024276
3024277
3024279
3024278
3024282
3024280
3024281
SOLAR MANAGER PROBE - COLLECTOR Probe for collectors, related to PRO electronics SOLAR MANAGER PROBE - CYLINDERS Probe for cylinders, related to PRO electronics SOLAR MANAGER PROBE - CUFF TUBE Probe for PRO electronics, to be applied on the pipes
3024273
3024274
3024275
OVERVOLTAGE PROTECTION The device should be used in order to protect the susceptible temperature sensors in or at the collector against induced overvoltages. In the case of local thunderstorms, voltage peaks which could destroy the sensor can be induced in the sensor cable. The protector diodes in the Overvoltage protection limit these overvoltages to a value harmless to the sensor. The best way to protect the sensor is to install this connecting box close to the sensor. LAN INTERFACE - SOLAR MANAGER PRO It is designed for the direct connection of the controller to a PC or router. It enables easy access to the controller via the local network of the owner. Thus, controller access, system parametrisation and data read-out can be e ected from every workstation of the network. ALARM MODULE PRO It is to be connected to the VBus® of the controller and issues an optical signal via the red LED if a failure has occurred. It has a potential-free relay output, which can e.g. be connected to a building management system (BMS) to issue a general warning in the case of a system failure.
3024284
3024283
3024292
| 51
Made with FlippingBook Annual report