2
Before arriving at job site
a1. _____ Ensure you have the required tools a1a. _____ Voltmeter a1b. _____ “True RMS” Ammeter
a1c. _____ 0” to 10” Manometer Gauge (Ex: Dwyer 477AV-0) used to measure profile pressure. Tubing fittings in the AMU are ¼” hose barb. a1d. _____ 0” to 200” Manometer Gauge (Ex: Dwyer 477AV-3) used to measure gas pressure. Test port fittings in the AMU are ¼” female pipe threads. (hose barb not included) a1e. _____ Basic hand tools including but not limited to: screwdrivers, wrenches, plyers, pipe wrench, wire strippers, technicians screw drivers, allen wrenches, drill and bits/drivers, electrical tape, Teflon tape, wire nuts, 1/8” hose barbs, ¼” hose barbs, etc. a1f. _____ Printed copy of this document so that items can be checked off, voltages/pressure info can be filled in, and operator training signatures can be obtained. a2. _____ Request photos of the incoming power wires to the disconnect from the customer to ensure the unit has power. If photos are not available, get signature from customer stating that the power has been connected and is ready for start-up. a3. _____ Request photos of field wiring connections: a3a. _____ exhaust fans a3b. _____ light fixtures a3c. _____ air solenoid a3d. _____ AMU to Remote a3e. _____ Inlet damper actuator a3f. _____ temperature probe If photos are not available, get signature from customer stating that the connections have been completed and unit is ready for start-up. a4. _____ Request photo of gas line connected to unit preferably with gauge showing the gas pressure. If photo is not available, get signature from customer stating that gas is connected and is at the proper pressure and unit is ready for start-up. a5. _____ Request photo of the tubing in the remote connected from the pressure sensor and the booth wall. If photo is not available, get signature from customer stating that the tubing is connected and ran to the booth and that the unit is ready for start-up. a6. _____ Using the serial number or job number of the AMU, contact RTT for a digital copy of the operation & maintenance manual. Phone: 972.772.1919 Email: techsupport@rttsolutions.com a7. _____ Using steps a9 through a16 below, familiarize yourself with the operation of the Corel controller. You will need to know how to login, adjust booth pressure, adjust cure recipes, etc. a8. _____ Using the operation manual, familiarize yourself with the sequence of operation of the unit.
2
Made with FlippingBook - professional solution for displaying marketing and sales documents online