fleetguard fit led air filter restriction indicator SK15967: $165.00 Do you trust your truck’s indicator when it comes to the air filter’s restriction level? Or, if your truck isn’t so equipped, do you wish you could monitor the air filter’s status? Fleetguard has introduced its FIT air restriction indicator, which will monitor the air filter status in real time. Its instant reading provides an accurate check on filter restrictions and eliminates air cleaner over-service. The sensor has a built in LED-indicator light that will stay lit when power is applied. A green light indicates a clean (low level of restriction) filter, a yellow light for when some contamination is detected, and a red light for significant contamination. The kit comes with instructions and the necessary hardware for installation in the factory air box, whether your truck came with or without the mechanical indicator.
Motor Mount REINFORCEMENTS ‘98.5-‘02, 24V ES_51116G: $62.68 ‘94-‘98, 12V ES_51114G: $73.58 Motor mount inserts sold in Black only.
NOTE: These are not replacement bushings, just reinforcements.
Polyurethane heavy-duty Engine Mounts (‘89-’93) PB2710: $169.00 pair These are solid polyurethane inserts with an internal locking system where the factory ones have an external safety lock. Features stainless steel hardware. Fits all Dodge pickups equipped with the Cummins engine from ‘89-‘93. Mounts: 3” x 3-1/2” and 1-3/4” thick. These are not inserts that fit inside the stock rubber, but a replacement for the whole rubber mount. To install, remove the old rubber from the engine mount and replace with these. Polyurethane heavy-duty Engine Mount insertS ‘94-’02 PB2453KIT: $199.95 pair These are a solid polyurethane mount where the factory ones are rubber with gapped holes in them.
BD POWER Killer Grid Heater Upgrade Kit (‘07.5-‘24, 6.7L 2500/3500/4500/5500) BD-1041520: $201.95 The Killer Grid Heater Upgrade Kit is purpose-built to address a major flaw in the 6.7L Cummins engine that can result in total engine destruction. The problem lies in the electrical connection to the intake grid heater. When powering the grid heater, 200 amps pass through a small bolt and nut inside the intake and over time is known to deteriorate and eventually arc and break off. This nut drops into the engine, leading to extensive damage to the piston, head, and valves. This kit upgrades that flawed electrical circuit by eliminating the problematic bolt and nut inside the intake while retaining stock functionality of the heater, is cost-effective, and is easy to install. • Eliminates the problematic grid heater bolt and nut that could lead to engine damage • Allows for full heat output with the stock intake grid heater • Easy installation with no modifications or tuning required • Kit includes replacement hardware and gaskets, along with special tools required for the job • Self-locking threads built into the lower busbar which will prevent the connection from backing out and compromising electrical connection
HEAVY-DUTY REAR ENGINE/TRANSMISSION POLYURETHANE MOUNT (‘89-‘02, 2500/3500) ‘94-‘02 PB2852 $119.00 ‘89-‘93 PB1604 $30.95 pair (‘89-‘93 4x4 only) This heavy duty, polyurethane bushing
PB2852 shown
is a direct replacement for the stock mount. Fits in the same location, easy to install.
54 Ram Turbo Diesel Parts & Accessories #128
Get Ram Cummins technical information at our website: https://www.genosgarage.com/tech_info
Made with FlippingBook Ebook Creator