Parameter Menu Bar (for Tool Configurations)
Multi Sequence
Multi Sequence
Press Muti Sequence in the top Parameters Menu Bar.
Each tool supports two Multi sequence (MS), one MS consists of up to 10 steps. Select the tool's Preset number MA (Multi sequence A) or MB (Multi sequence B) and hold the lever down to automatically perform the steps of that MS. Multi sequence in progress will be terminated if a failure or error occurs during each step.
Command Setting Parameters
Command
Description
None
-
Fastening
Tightening with the preset you set. Exit Multi sequence operation.
End
Delay
Delay for set time.
Select preset #
Change to Preset that you set. Reverse the number of turns set.
Loosening
Jump
Go to the set Step.
Set the number of tightening sets in Count A. Subtract 1 from Count A and move immediately to the next step if the value is not zero and move two steps if zero.
Count value = A
Sub if (A)
From the Command Column, select a process step.
The chart on the left describes each Command option. See the next page for an example of a Mult Sequence Step program.
MountzCom III User Manual
29
Made with FlippingBook Annual report maker