Web Interface – Configuration
PFC When PFC (802.1Qbb Priority Flow Control) is enabled on a port then flow control on a priority level is enabled. Through the Priority field, range (one or more) of priorities can be configured, e.g. '0-3,7' which equals '0,1,2,3,7'. PFC is not supported through auto negotiation. PFC and Flowcontrol cannot both be enabled on the same port. Maximum Frame Size Enter the maximum frame size allowed for the switch port, including FCS. The range is 1518-9600 bytes.
Excessive Collision Mode Configure port transmit collision behavior:
Discard: Discard frame after 16 collisions (default) Restart: Restart backoff algorithm after 16 collisions
Frame Length Check Configures if frames with incorrect frame length in the EtherType/Length field shall be dropped. An Ethernet frame contains a field EtherType which can be used to indicate the frame payload size (in bytes) for values of 1535 and below. If the EtherType/Length field is above 1535, it indicates that the field is used as an EtherType (indicating which protocol is encapsulated in the payload of the frame). If "frame length check" is enabled, frames with payload size less than 1536 bytes are dropped, if the EtherType/Length field doesn't match the actually payload length. If "frame length check" is disabled, frames are not dropped due to frame length mismatch. Note: No drop counters count frames dropped due to frame length mismatch
4.9.2
Port Configuration Buttons Save: Click to save all changes. Reset:
Click to undo any changes made locally and revert to previously saved values. Refresh: Click to refresh the page. Any changes made locally will be undone.
Confidential
User Guide: CE Services
Page 148
Made with FlippingBook interactive PDF creator