Web Interface – Configuration
Serval2 NID board limitations: Port 5-12 can be configured for 100M, 1G or 2.5G speed. In 2.5G speed mode the SyncE hardware is not able to lock, because the recovered clock output frequency does not match the SyncE hardware's frequency options. Priority The priority for this clock source. Lowest number (0) is the highest priority. If two clock sources has the same priority, the lowest clock source number gets the highest priority in the clock selection process. SSM Overwrite A selectable clock source Quality Level (QL) to overwrite any QL received in a SSM. If QL is not Received in a SSM (SSM is not enabled on this port), the SSM Overwrite QL is used as if received. The SSM Overwrite can be set to QL_NONE, indicating that the clock source is without any know quality (Lowest compared to clock source with known quality). Hold Off The Hold Off timer value. Active loss of clock Source will be delayed the selected amount of time. The clock selector will not change clock source if the loss of clock condition is cleared within this time. ANEG Mode This is relevant for 1000BaseT ports only. In order to recover clock from port it must be negotiated to 'Slave' mode. In order to distribute clock the port must be negotiated to 'Master' mode. This different ANEG modes can be activated on a Clock Source port: Prefer Slave: The Port will be negotiated to 'Slave' mode if possible. Prefer Master: The Port will be negotiated to 'Master' mode if possible. Forced Slave: The Port will be forced to 'Slave' mode. The selected port in 'Locked' state will always be negotiated to 'Slave' if possible.
LOCS Signal is lost on this clock source.
SSM If SSM is enabled and not received properly. Type of SSM fail will be indicated in the 'Rx SSM' field. WTR Wait To Restore timer is active. Clear WTR Clears the WTR timer and makes this clock source available to the clock selection process.
Confidential
User Guide: CE Services
Page 296
Made with FlippingBook interactive PDF creator