Command Line Interface
access-list redirect interface { <port_type> <port_type_id> | ( <port_type> [ <port_type_list> ] ) } interface: <port_type>, values are: * all switches or all ports GigabitEthernet: set specific Gigabit Ethernet Port number <port-list>: port list in 1/1-8 Access-List Shutdown Shut down incoming port. The shutdown feature only works when the packet length is less than 1518 (without VLAN tags). Syntax: access-list shutdown Note: To re-enable a port that was shut down, use the <0-255>: Policy ID
Access-List Port-State command described on page 46.
2.3.22.2 (Interface – Port Type) Aggregation Create an aggregation group. Syntax: aggregation group <v_uint> Example: aggregation group 1 2.3.22.3 (Interface – Port Type) Description Syntax: description <v_line>
<line>: Up to 256 ASII characters describing this interface.
2.3.22.4 (Interface – Port Type) Do
Use the do command to run exec commands in config mode. Syntax: do <command>
2.3.22.5 (Interface – Port Type) dot1x
Dot1x is the IEEE Standard for port-based Network Access Control. This command sets dot1x per port.
Dot1x guest-vlan Enables/disables guest VLAN. Syntax: dot1x guest-vlan
Confidential
User Guide: CE Services
Page 47
Made with FlippingBook interactive PDF creator