6.2
VeriPHY
This page is used for running the VeriPHY Cable Diagnostics for 10/100 and 1G copper ports. ), to run the diagnostics. This will take approximately 5 seconds. If all ports are selected, this can take approximately 15 seconds. When completed, the page refreshes automatically, and you can view the cable diagnostics results in the cable status table. Press the Start button (
Note:
VeriPHY is only accurate for cables of length 7 - 140 meters.
10 and 100 Mbps ports will be linked down while running VeriPHY. Therefore, running VeriPHY on a 10 or 100 Mbps management port will cause the switch to stop responding until VeriPHY is complete.
6.2.1
VeriPHY Cable Diagnostics Port Set or show the port requesting VeriPHY Cable Diagnostics. Cable Status Table Port: This column displays the port number for the status row
6.2.2
Pair n: This column displays the status of the cable pair. The possible values are: OK: Correctly terminated pair Open: Open pair
SMB - CLI UM
Rev: 1.1
Page 261 of 275
www.amphenol-socapex.com
Tel : +33(0)4.50.89.28.00
Made with FlippingBook interactive PDF creator