Switchport Trunk Allowed VLAN Set allowed VLAN characteristics when interface is in trunk mode. Set the following additional parameters: <vlan_list>: VLAN IDs of the allowed VLANs when this port is in trunk mode all: all VLANs none: no VLANs add: add VLANs to the current list remove: remove VLANs from the current list except: all VLANs except the following Syntax: switchport trunk allowed vlan { all | none | [ add | remove | except ] <vlan_list> } Switchport Trunk Native VLAN Set native VLAN when interface is in trunk mode. Set the following parameter: <vlan_id>: VLAN ID of the native VLAN when this port is in trunk mode Syntax: switchport trunk native vlan <pvid>
Switchport Trunk VLAN Tag Native Tag Native VLAN. Syntax: switchport trunk vlan tag native
2.3.16.27
(Interface – Port Type) Thermal-Protect Port-Prio Set the thermal priority for the interface. Set the priority values: <prio>: priority values can be from 0-3 Syntax: thermal-protect port-prio <prio> Interface – VLAN Set the VLAN interface configuration parameters. Syntax: interface vlan <vlist> vlan: VLAN interface configurations <vlist>: List of VLAN interface numbers, 1~4095 Input: AMP8MG(config)# interface vlan 1 Output (prompt change to interface mode – vlan): AMP8MG(config-if-vlan)# The following commands are available in interface mode – vlan:
2.3.17
2.3.17.1
(Interface – VLAN) Do Run exec commands in config mode.
SMB - CLI UM
Rev: 1.1
Page 39 of 275
www.amphenol-socapex.com
Tel : +33(0)4.50.89.28.00
Made with FlippingBook interactive PDF creator