rx:
setting source port to rx will mirror ingress traffic
tx:
Setting source port to tx will mirror egress traffic
2.3.26
No Negate a command or set its defaults. No Commands (a-b) no aaa authentication login { console | ssh | http } no access management no access management <access_id_list> no access-list ace <ace_list>
no aggregation mode no banner [ motd ]
no banner exec no banner login
No Commands (dot1x) no dot1x authentication timer inactivity no dot1x authentication timer re-authenticate no dot1x feature { [ guest-vlan ] [ radius-qos ] [ radius-vlan ] }*1
no dot1x re-authentication no dot1x system-auth-control no dot1x timeout quiet-period no dot1x timeout tx-period
No Commands (enable) no enable password [ level <priv> ] no enable secret { [ 0 | 5 ] } [ level <priv> ] No Commands (Green-Ethernet) no green-ethernet eee optimize-for-power no green-ethernet led interval <0~24> no green-ethernet led on-event [ link-change ] [ error ]
No Commands (h-i) no hostname no interface vlan <vlist>
No Commands (ip) no ip http secure-redirect no ip http secure-server no ip igmp snooping no ip igmp snooping vlan [ <v_vlan_list> ] no ip igmp unknown-flooding no ip route <v_ipv4_addr> <v_ipv4_netmask> <v_ipv4_gw>
No Commands (l-m) no lacp system-priority <v_1_to_65535> no lldp holdtime
no lldp reinit no lldp timer no lldp transmission-delay no logging host
SMB - CLI UM
Rev: 1.1
Page 45 of 275
www.amphenol-socapex.com
Tel : +33(0)4.50.89.28.00
Made with FlippingBook interactive PDF creator