Output: AMP8MG(config-snmps-host)# The following option are available from the SNMP host: do: to run exec commands in config mode end: go back to EXEC mode exit: exit from current mode help: description of the interactive help system host: host configuration informs: send Inform messages to this host no: negate a command or set its defaults shutdown: disable the trap configuration traps: trap event configuration version: set SNMP trap version
Note:
General commands are described elsewhere in this document (see section 2.3.17 Interface – VLAN on page 39). Commands specific to SNMP-Server are described below.
2.3.31.7
SNMP-Server Host Commands (SNMP-Server Host) Informs Send Inform messages to this host. Syntax: informs retries <retries> timeout <timeout> <retries>: number of times to retry sending inform message, value can be from 0 to 255 <timeout>: timeout interval, value can be from 0 to 2,147 seconds (SNMP-Server Host) Traps Set the trap event configuration. Syntax: traps [ aaa authentication ] [ system [ coldstart ] [ warmstart ] ] [ switch [ stp ] [ rmon ] ] aaa : AAA event group system: system event group coldstart: cold start event warmstart: warm start event switch: switch event group rmon: RMON event stp: STP event system: System event group
SMB - CLI UM
Rev: 1.1
Page 53 of 275
www.amphenol-socapex.com
Tel : +33(0)4.50.89.28.00
Made with FlippingBook interactive PDF creator