SNTP Server Configure SNTP server. Syntax: sntp server ip-address { <ipv4_var> } <ipv4_var>: ipv4 address
2.3.33
Spanning-Tree Configure Spanning Tree protocol.
2.3.33.1
Spanning-Tree Aggregation Aggregation mode Syntax: spanning-tree aggregation Output (STP Aggregation Prompt): AMP8MG(config-stp-aggr)# Options: do:
To run exec commands in config mode
end:
Go back to EXEC mode
exit:
Exit from current mode
help:
Description of the interactive help system
no:
Negate a command or set its defaults
no spanning-tree no spanning-tree auto-edge no spanning-tree bpdu-guard no spanning-tree edge no spanning-tree link-type no spanning-tree restricted-role no spanning-tree restricted-tcn
2.3.33.2
Spanning-Tree Edge bpdu-Filter Enable BPDU filter (stop BPDU tx/rx). Syntax: spanning-tree edge bpdu-filter Spanning-Tree Edge bpdu-Guard Enable BPDU guard. Syntax: spanning-tree edge bpdu-guard
2.3.33.3
SMB - CLI UM
Rev: 1.1
Page 56 of 275
www.amphenol-socapex.com
Tel : +33(0)4.50.89.28.00
Made with FlippingBook interactive PDF creator