4.5
Green Ethernet – LED
Power Reduction Configuration The system status LED shows whether the system is running. The LED is green when system is running and no errors are detected. If errors has been detected the status LED will indicate this by blinking red. The LEDs power consumption can be reduced by lowering the LEDs intensity.
4.5.1
Led Intensity Timers LEDs intensity can be varied throughout the day. For example LED intensity can be lowered during night time, or turned off completely. It is possible to configure a different LED intensity for each of the 24 hours of the day. (Each one would occupy a unique time slot.) The LED intensity timer has the following configurable parameters:
Delete
Select this option to delete a LED configuration time slot
Default (Do not delete the configuration time slot.)
Start Time Set or show the time at which the LED’s intensity shall be set to the corresponding intensity. End Time Set or show the time at which the LED’s intensity shall be set to a new intensity. If no intensity is specified for the next hour, the intensity is set to the default intensity.
SMB - CLI UM
Rev: 1.1
Page 78 of 275
www.amphenol-socapex.com
Tel : +33(0)4.50.89.28.00
Made with FlippingBook interactive PDF creator