Intensity Set or show the LEDs intensity (100% = Full power, 0% = LED off, Default = 100%) Maintenance During maintenance of the switch (e.g. adding or moving users), a network administrator might want to have full LED intensity. Therefore, it is possible to specify that the LEDs shall use full intensity at specific period of time. Maintenance Time is the number of seconds that the LEDs will have full intensity after either a port has changed link state, or the LED pushbutton has been pushed. On Time at Link Change Set or show the number of seconds for LEDs to be at full intensity during link status change.
4.5.2
On at Errors
Set the LEDs to full intensity on errors
LEDs intensity not affected by errors (Default: this is the default)
4.5.3
IP Configuration Buttons Add Time: Click to add a new time slot Save: Click to save all changes Reset:
Click to undo any changes made locally and revert to previously saved values
SMB - CLI UM
Rev: 1.1
Page 79 of 275
www.amphenol-socapex.com
Tel : +33(0)4.50.89.28.00
Made with FlippingBook interactive PDF creator