4.12
Security – Switch – Access Management
The user can configure the access management table on this page. The maximum number of entries is 16. If the application’s type matches any one of the access management entries, it will allow access to the switch.
4.12.1
Access Management Configuration The access management configuration has the following parameters: Mode Set or show the access management mode operation. Enabled: Enable access management mode operation Disabled: Disable access management mode operation (This is the default mode.) Delete
Check to delete the entry. It will be deleted during the next save.
Do not delete the entry. (This is the default.)
VLAN ID Set or show the VLAN ID for the access management entry. Start IP Address Set or show the start IP address for the access management entry. End IP Address Set or show the end IP address for the access management entry.
SMB - CLI UM
Rev: 1.1
Page 88 of 275
www.amphenol-socapex.com
Tel : +33(0)4.50.89.28.00
Made with FlippingBook interactive PDF creator