Interior Flooring Manual
After Installation
Initial Maintenance No less than 48 hours after installation, initial maintenance must be performed. Refer to the corresponding Maintenance Guides (MG) available at www.lonseal.com . There are three guides available, one for each type of surface option available from Lonseal. High Gloss For use with the high gloss, factory-applied urethane finish (products will typically have UV in their name) Topseal For use with the matte, factory-applied urethane finish Unfinished Flooring For use with all floors without a factory-applied finish Protecting the Floor To reduce the chance of product damage or conflict with activities by other trades, Lonseal flooring should be the last finish material installed. Other trades must remain out of the work area and off the floor until the flooring contractor advises it is safe to enter or at least 72 hours after installation. Where trade work must take place on or around Lonseal flooring after installation, provide adequate protective covering using 1/4 in. (6.4 mm) thick minimum plywood panels in order to protect the flooring from damage caused by ladders, scaffolding, or construction traffic. Use of products such as cover guard ® , Ram Board ® , or similar may be suitable for light traffic or work only, as recommended by the manufacturer. These products are not a substitute for plywood when high point loads from ladders, scaffolding, or laden construction carts will be used on the installed flooring, as they may not fully distribute the load enough to avoid indentation or adhesive displacement.
Note: Kraft paper with certain dyes can cause permanent staining on the surface of the flooring.
Disclaimer: Lonseal accepts no responsibility for damage caused to the flooring or installation by work performed on or around the installation area. Sole responsibility for properly protecting the floor after it is installed belongs to the flooring or general contractor, including any products used to protect the flooring or installation.
LONSEAL ®
Page 16 of 17
Revised: 9.20.2024
Disclaimer: Printed documents are uncontrolled. Always refer to www.lonseal.com for the most current technical information.
Made with FlippingBook interactive PDF creator