TREX SELECT ® CLASSIC COMPOSITE STAIR RAILING Installation Instructions
HOW TO INSTALL CONTINUOUS (OVER THE POST) COCKTAIL STAIR RAILING
Cutting Post and Post Sleeve 8. C ut lower post/post
8
IMPORTANT NOTES: » 6 x 6 post sleeve cannot be used. Trex post mounts or joist mount posts cannot be used. Cutting post and post sleeve only apply to the Continuous (Over the Post) Cocktail railing. » THE TOP BOARD USED WILL NEED TO TERMINATE AT THE UPPER STAIR POST AS SHOWN BELOW. THE TOP BOARD WILL HAVE TO BE TOENAILED INTO THE SIDE OF THE POST IN THESE AREAS USING 2 APPROPRIATE COMPOSITE DECKING SCREWS – PRE-DRILLING IS RECOMMENDED.
sleeve at proper angle so this is flush with the top of the top rail.
Top stair rail
Post
9. Attaching Brackets on Top Stair Rail See instructions on page 5.
Measuring and Cutting Top Board
10
1. Installing Pressure-Treated Posts See instructions on page 3 .(See note above in regards to not cutting post/post sleeve). 2. Installing Post Sleeve Skirts and Post Sleeves See instructions on page 3.
3. Measuring and Cutting Bottom Stair Rail See instructions on page 4.
10. Measure accordingly and cut top boards to appropriate length of railing span also allowing for additional material that will be installed over the lower stair rail post.
4. Marking Location for Foot Block to Bottom Rail See instructions on page 4.
5. Attaching Brackets to Bottom Rail See instructions on page 4. 6. Attachment of Bottom Rail to Post See instructions on page 4. 7. Measuring and Cutting Top Stair Rail See instructions on page 4.
Attaching Top Board to Top Stair Rail 11. Place inverted top board (place top side of board down) on clean, flat surface. 11
6
Have Questions? 1–800–BUY–TREX
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
SCST-0626
Made with FlippingBook interactive PDF creator