SF1000E Operator Manual | 1.2021

9. Problem: Down draft on chimney caused by one or more of the following.

Possible Causes:

Remedies:

• Flue has a cold spot which inhibits exhaust discharge from rising properly.

• This problem may occur in factory built flues because the insulation has settled or a seam has ruptured. In masonry flues, mortar loss may be causing seepage of cooler outside air into the stack. Check entire flue for structural integrity and leakage. Correct or repair as needed, or replace or re-line the chimney.

• There is an obstruction outside the chimney, such as a tree. • Flue is located too close to the peak of the roof or does not rise above it to provide the proper draft.

• Remove obstruction.

• Increase chimney height.

10. Problem: Odor detected in home during initial firing Possible Causes: Remedies:

• There is an oily film that remains on the steel after the manufacturing process. Firing the furnace has raised the temperature of the fire box to a level that is sufficient to vaporize the residue

• The odor should disappear after a few hours of usage.

11. Problem: Excessive smoke discharge from fuel door during reloading. Possible Causes: Remedies:

• Excessively long run of stove pipe from furnace to flue

• See Troubleshooting Problem #6.

• Too many elbows.

• See Troubleshooting Problem #6.

• Insufficient draft

• See Troubleshooting Problem #6.

• Excessive smoke accumulation.

• See Troubleshooting Problem #9.

• Negative pressure in furnace area.

• Provide fresh air to the furnace area.

22

Made with FlippingBook - professional solution for displaying marketing and sales documents online