Push/Pull Cylinders
Block Pull Cylinders
Single Acting No mounting hardware required, just bolt in place to secure these “draw” action cylinders. Adjustable force ranging from “negligible” to maximum cylinder capacity, just adjust the input pressure. Normally extended piston provides a simple device for actuating clamping mechanisms, device manipulation or disappearing spring crowders. Threaded plunger ends allow the attachment of custom end treatments or the use of bolts to pull “C” washers. Hardened chrome alloy steel pistons won’t “mushroom” or wear unevenly. Vent port with bronze filter gives the cylinder a place to “breathe” and helps keep chips from drawing past wipers. Specially designed springs run longer, require less maintenance.
G-10
Cylinder Capacity (lbs.)* Retract
Body Dimensions (in.)
Effective Piston Area (sq. in.)
Oil Capacity (cu. in)
Model No.
Stroke (in.)
Single Acting (S/A)
Cylinders, actuated hydraulically 1 direction, spring returned.
25-1110-11 25-1110-12 25-1115-11 25-1115-12
1.00 2.00 1.00 2.00
0.268 0.536 0.774 1.548
1,300
1.75 x 2.00
0.267
3,800
2.00 x 2.50
0.773
* Cylinder capacities are listed at 5,000 psi maximum operating pressure. The output force is adjustable by varying hydraulic pressure. To determine approximate output force, use the following formula: Effective Piston Area X Input Pressure = Clamping Force. (Actual force may vary slightly due to friction and/or return springs.)
ILS251100 REV F
© Vektek, July 2024
800-992-0236
www.vektek.com
Made with FlippingBook - Online magazine maker