Accessory Valves
Compact Manifold Mount Sequence Valve
Compact Manifold Mount Valve is 100% stainless steel construction and resists the corrosion which can cause other styles to “misfire.” Direct acting poppet style construction, adjustable cartridge type construction. Cartridge may be installed directly into your manifold. Two-port design eliminates need for third fluid line to drain bypass flow (internal leakage) back to system reservoir. True sequence design allows full system pressure downstream of valve after opening. n Recommended Filtration: 25 Micron (NOM) / 40 Micron (ABS) (minimum).
Operation : The VektorFlo® sequence valve operates as a pressure sensitive, normally closed element in a clamping system. When fluid first enters the system at low pressure, the valve is closed, blocking the flow of fluid to devices downstream. After devices upstream of the valve have moved into position and pressure begins to increase, the increasing pressure overcomes the spring force holding the valve closed, forcing the poppet off its seat allowing fluid flow through the valve. After downstream devices have positioned and clamped, and pressure has increased to equal upstream pressure, the entire system pressure rises to the maximum level setting on the hydraulic power supply. When unclamping, as pressure falls, force from the adjustment spring pushes the poppet back onto its seat.Fluid trapped in the downstream circuit flows back through the check valve to return to the power unit reservoir.
Manifold Mount Sequence Valve Model No. Set Pressure Range A B Max Flow Rate 70-4410-01 300 to 900 psi 4.41 2.36 3.0 gpm 70-4410-02 750 to 5,000 psi 3.81 1.74 1.5 gpm *Maximum Inlet Pressure for sequence valve is 5,000 psi. Excess flow voids warranty
.50 HEX
Counterbored for o-rings that are used for manifold mounting. .09/ .25 OIL FEED HOLES
NOTE: When using multiple sequence valves. For pressure set range 300 to 900 psi a 100 psi spread between pressures is recommended. For pressure set range 750 to 5000 psi a 500 psi spread between pressures is recommended. Maximum system flow rate is 1.5 gpm for all VektorFlo® special function valves unless oth- erwise noted.
.94 HEX
.22
L-11
M-11
TIGHTEN TO 35 FT-LBS (47.5 Nm) TORQUE
B
.4 38 MANIFOLD MOUNT PRESSURE OUTLET PORT USES 2-011 O-RING
A
2X
.375
.500
2X 30
2X
.218 THRU
1.312
2X .43
1.67
2X .195
2X
2X .66
2X
.052
.531
40
1.25
.438 MANIFOLD MOUNT PRESSURE INLET PORT USES 2-011 O-RING
1.062
2X .73
ILS704403 REV A
1.46
For proper sealing, mating surface should be flat to 0.003 in. with a maximum 63 R a µin. surface finish.
2X .250 OIL FEED HOLE
www.vektek.com
800-992-0236
© Vektek, July 2024
Made with FlippingBook - Online magazine maker