TREX® LIGHTING–POST SLEEVE
Follow Instructions below for all Pressure-Treated Post with Composite and Aluminum Sleeves Unless Otherwise Stated**
4 x 4 Composite Post Sleeve 6 x 6 Composite Post Sleeve All-in-One Composite Post Sleeve Aluminum Post Sleeve
INSTALLING PRESSURE-TREATED POSTS 1. .Review COMPATIBLE POST WITH LIGHTING CHART to determine the correct composite sleeve that is suitable with lighted post cap, under rail lighting, as well as approved railing systems used.
2. R efer to local building code requirements prior to attaching pressure-treated posts.
PREPARING POST SLEEVES FOR LIGHTED POST CAPS 3. E nsure wiring is installed to pressure-treated post as previously outlined in instructions. PREPARING POST SLEEVES FOR UNDER-RAIL LIGHTING
4
4. If installing under-rail lighting, drill a 1/2" hole through deck board at wire location. Drill hole directly beside pressure-treated post to allow for post skirt to hide hole location. Note: This step might not be necessary if there is a large enough gap between deck board and pressure-treated post.
10
LIGHT-OVERVIEW-1026
Made with FlippingBook Annual report maker