Refer to exploded view drawings included with your spray booth. 1. Starting with exhaust chamber at either rear corner, bolt one corner panel and one rear wall corner panel together (use tie channel where applicable). 2. Bolt opposite rear sidewall panel to rear wall panel. 3. Bolt all rear wall panels in place. 4. Bolt tie channel along top edge of rear wall panels. 5. Place exhaust fan panel above side and rear wall panels and bolt in place. 6. Insert filter filler panels between sidewall, roof panels and exhaust chamber. Bolt in place.
CHAMBER SIDE PANEL
FILTER FILLER PANEL
BOOTH SIDE PANEL
7. Following exploded view drawings, continue alternately assembling wall panels and roof panels to each other until you reach front end of booth. Finish off roof section by attaching fire curtain if needed. If booth has front doors, no fire curtain is needed. 8. Verify walls are plumb and booth is square and on floor layout marks. Tighten all mounting hardware. 9. Anchor floor channel to floor at a minimum of every 12 inches. 10. Caulk all panel joints inside the booth with the caulk provided. Do not use a silicone caulk. 11. If booth is supplied with a personnel door or product doors, apply gasket to perimeter of all door openings. Attach door hardware and adjust latches. Level door with doors off, then attach doors to hinges.
DOOR LATCH AND SEAL DETAIL
DOOR FRAME BASE DETAIL
PRODUCT DOOR DOOR SWEEP DETAIL
38
Made with FlippingBook - professional solution for displaying marketing and sales documents online