Technical Training
Basic Technical Training Standard/ V8 2023-05-02
BTT Mechanical
BTTM
BTT Electrical
BTTE
BTT Hydraulic
BTTH
BTT Bolt Tightening
BTTB
BTT Installation
BTTI
Table 5.6.1 – GWO BTT module course codes
5.7 Participant Prerequisites All personnel participating must meet the participant prerequisites described in the GWO Requirements for Training.
There are additional prerequisites for both the Bolt Tightening and Installation modules:
a. Before attending the BTT Bolt Tightening Module participants must first complete the BBT Mechanical Module. b. Before attending the BTT Installation Module participants must first complete both the BTT Mechanical and BTT Bolt Tightening modules. Furthermore, personnel in the wind service industry must be able to read and write to a sufficient standard to be able to carry out instructions and complete the required documentation. It is an advantage if participants are able to read, speak and write English. 5.8 Instructor Qualification Prerequisites A competent GWO BTT instructor must adhere to the instructor requirements for GWO training.
6. GENERAL RESOURCES REQUIRED TO DELIVER THE BTT MODULES
The training provider shall ensure that staff, facilities, and equipment are in place to support the training of participants. 6.1 Practical Training Facilities A practical workshop is required that has enough space to accommodate 8 participants, with a respective work area each of approximately 3 square metres. 6.2 Handouts Handouts must be given to the participants containing, as a minimum:
a.
Electrical symbols mentioned in the BTT Standard
Global Wind Organisation www.globalwindsafety.org
13 / 262
Made with FlippingBook Digital Proposal Creator