Technical training
Basic Technical Training / V8 2023-05-02
b.
Stripping tools to remove cable insulation
c. Crimping tools for signal cables and main cables: manual and hydraulic tools
Explain and demonstrate how to cut and crimp small signal cables:
a.
Shielded and unshielded
b.
Rubber and PVC insulation types
Explain and demonstrate how to cut and crimp main power (LV) cables:
a. Copper and aluminium (special attention to correct cable die-set)
b.
Rubber and PVC insulation types
c. Install heat/cold shrink tube on top of cable and cable lug after cable lug has been crimped
Facilitate practice for the participants in cutting and crimping small signal cables and main power (LV) cables
Give constructive feedback on the participants’ cutting and crimping of small signal and main power LV cables
The participants shall:
Practice cutting and crimping small signal cables:
a.
Shielded and unshielded
b.
Rubber and PVC insulation types
c. Install heat/cold shrink tube on top of cable and cable lug after cable lug has been crimped
Practice cutting and crimping main power (LV) cables:
a. Copper and aluminium (special attention to the correct cable die-set)
b.
Rubber and PVC insulation types.
ELEMENT 9.7 - MARKING, ROUTING AND TERMINATION OF ALL CABLE TYPES
Learning objectives:
84) The participants can describe typical faults during termination, and ways to mitigate these typical faults (Knowledge, basic level) 85) The participants can perform the marking, routing and termination of all cable types (Skills, intermediate level)
Global Wind Organisation / www.globalwindsafety.org
206 / 262
Made with FlippingBook Digital Proposal Creator