Technical training
Basic Technical Training Standard / V9 2024-06-24
• Tool set for crimping wires bigger than 35mm2 (electric or electro-hydraulic) – 1 set for 4 participants • Log Out Tag Out kit (this kit should not be required if not needed considering the setup available for the practices)
•
Mock-up for cable work including:
• Electrical cabinets with standard DIN rails for mounting terminals (clamp, screw type)
•
Clamp, screw type terminals
•
Cable glands
•
Cable trays
•
Bus bars (copper) with holes to connect cables with cable lugs
Any equipment used during this GWO training module shall meet or exceed the minimum requirements of the national standards in the country where the training is taking place. When working in a country where there is no applicable national standard then the equipment shall meet or exceed the minimum requirements of the European standards.
Global Wind Organisation / www.globalwindsafety.org
231 / 269
Made with FlippingBook Digital Proposal Creator