CONTURO Edge Bander booklet

Simply tilt the CONTURO in the stationary unit to affix edging to a mitred edge. The scale indicates the angle in degrees. Stationary attachment of edging to mitred workpieces



Loosen both clamping screws on the angle scale, set the desired angle and tighten the clamping screws again.

Adjust the edging height in the usual way. TIP Edging for mitred edges requires a slightly larger over- hang. For example, edging 35 mm (1-3/8”) high is used on a 19 mm (3/4”) panel with a 45° edge.



Use the guide rail adapter to ensure the workpiece is guided parallel and prevent the edging from running off course. Adjust the guide rail adapter to the thickness of the edging you are using. Available thickness settings are 0.5, 1, 2 and 3 mm.

Select the desired speed before starting the gluing process as you will always need both hands on the workpiece when gluing.


Made with FlippingBook - Online catalogs