HORIZONTAL LIFELINE SYSTEM INSTRUCTION MANUAL
3.3 SYSTEM UNINSTALLATION
It may be difficult to release the lock pin while the lifeline is in full tension.
Move the tensioner handle in clockwise direction to release the internal brakes
To release the lock pin
Activate the tensioner handle
Now, rotate the tensioner handle in anti-clockwise
Deactivate the tensioner handle and retract the life line
Once the brake are released, push
down the lock pin to release the tension in lifeline.
direction to release the tension.
A. PERSONAL FALL ARREST SYSTEM COMPONENTS: Inspect and don a full body harness according to the manufacturer’s instructions. Attach the connecting subsystem (energy absorbing lanyard or SRL) to the dorsal connection on the harness. B. CONNECTING TO THE HLL SYSTEM: Approach the work area using the appropriate access equipment. Connect the personal fall arrest system to the Horizontal Lifeline (HLL). Connectors must meet all compatibility and strength requirements.
WARNING Both ends of the lifeline must be securely attached to appropriate anchors when in use. Never attach the end of the lifeline to a harness to use it in the manner of a winch or SRL.
C. HAZARDOUS SITUATIONS: Do not take unnecessary risks, such as jumping or reaching too far from the edge of the working surface. Do not allow the connecting subsystem to pass under arms or between feet. To avoid inadequate clearance, do not climb above the HLL. To avoid swing fall hazards, do not work too far from either side of the HLL. D. TWO PERSONS CONNECTED TO THE HLL: When a person falls while connected to the HLL, the system will deflect. If two persons are connected to the same HLL, and one person falls, the second person may be pulled off the working surface due to deflection. The potential for the second person falling increases as the HLL span length increases. The use of independent HLL systems for each person, or shorter span length, is recommended to minimize the potential of the second person falling. E. FREE FALL: The personal fall arrest system must be rigged to limit free falls to 6 ft. (1.8 m) or less when using an energy absorbing lanyard, or such that the SRL is overhead and without slack, according to OSHA requirements. F. SHARP EDGES: Avoid working where the connecting subsystem or other system components will be in contact with, or abrade against, unprotected sharp edges. If working around sharp edges is unavoidable, a protective cover must be used to prevent cutting of the Personal Fall Arrest System (PFAS) components. G. IN THE EVENT OF A FALL: The responsible party must have a rescue plan and the ability to implement a rescue. Tolerable suspension time in a full body harness is limited, so a prompt rescue is critical. H. RESCUE: With the number of potential scenarios for a worker requiring rescue, an on- site rescue team is beneficial. The rescue team is given the tools, both in equipment and techniques, so it can perform a successful rescue. Training should be provided on a periodic basis to ensure rescuers proficiency.
www.bsafe.com.au 1300 783 606 I 5
Made with FlippingBook flipbook maker