5.
OPERATION
5.1 Start-Up
!!! CAUTION!!!
The blower compartment bolt-on panel must be installed before operating the dust collector.
Inspect the installation area and make certain no tools, parts, etc. have been left anywhere on or inside the unit. Check the fan discharge to make certain it is free from all debris. Start fan motor and check for proper rotation. A rotation arrow is located on the fan housing. If the fan is rotating in the opposite direction, disconnect the power to the motor starter, interchange any two (2) wires on the output side of the starter (three- phase systems only), engage starter disconnect, then start fan and recheck rotation. Before each start-up, verify that hopper slide gates are closed. Clean Air Industries Amtech ATC High Efficiency Cyclone Dust Collector drum lids with gasketing and drums must be firmly in place and tight fitting. Ductwork slide gates must be open. Check exhaust for any obstruction. To operate the cyclone dust collector, simply turn on the blower.
Running fan in incorrect rotation for an extended period of
NOTE:
time will cause fan motor damage and reduce life of fan motor.
Adjust airflow with volume control damper(s) (not supplied by Clean Air Industries ) on individual ductwork drops.
5.2 CHECK LIST
Always verify that any hopper slide gates are closed and that the doors, drum lids and gaskets are in place. The material being collected will not separate from the airstream if any leakage occurs around the base or drum. Failure to adhere to these instructions may also cause the motor to overload. Verify that exhaust air remains visibly clean. If an emission develops, examine drums, drum lids, etc. for possible leaks.
Page 13
sales@clean-air.com
1-866-665-1829
www.clean-air.com
Made with FlippingBook Annual report maker