Maintenance
Recovery from freezing The washer may freeze when the temperature in its location drops below 32 °F (0 °C). 1. Turn off the washer, and then unplug the power cord. 2. Pour warm water over the tap to loosen the water hose. 3. Disconnect the water hose, and soak it in warm water. 4. Pour warm water into the drum (tub) and leave it for about 10 minutes. 5. Reconnect the water hose to the tap. NOTE If the washer still doesn’t operate normally, repeat the steps above until it operates normally. If the washer will not be used for an extended period of time Avoid leaving the washer unused for an extended time. If you intend to leave the washer unused for a long period of time, follow the directions below: 1. Press POWER , and then select RINSE+SPIN . 2. Empty both the drum and the tub, close the door, and then press START/PAUSE . 3. When the cycle is complete, close the tap and disconnect the water hoses. 4. Turn off the washer, and then unplug the power cord. 5. Open the doors to let air circulate through the drum and the tub. Self Clean Certain usage and environmental conditions may result in some residue build-up or odor in the washer tub. To prevent this build-up of residue or odor causing bacteria and keep your washer tub fresh and clean, perform the Self Clean cycle at least once a month or every 20 cycles. Perform the recommended procedure below when using the Self Clean cycle. 1. Remove all items from the washer tub and ensure the tub is empty. Laundry left in the tub during the Self Clean cycle may be damaged. 2. Press POWER . 3. Press Self Clean . 4. Press and hold START/PAUSE . NOTE • The water temperature for Self Clean is defaulted to Hot. This temperature cannot be changed. Upper washer
English 58
FlexWash_WV9900M_DC68-03768A-07_EN.indd 58
2019-05-23 PM 2:55:25
Made with FlippingBook - Online magazine maker