4.4 Booth Assembly When assembling the booth, leave bolts finger tight until the entire booth is assembled. All flanges should face outward. Install bolts from inside so nut is outside of the booth. Use a drift pin to align panel holes when two or more panels are difficult to align by hand. Lay out all floor channel for exhaust chamber and walls. As you attach wall panels together, they will also bolt to the floor channel.
Prevent serious injury or death. Most booth components weigh 50-500 lbs. Use adequate lifting devices to raise, move and install booth components. WARNING Prevent equipment damage. Spray booth roof will not support a person. Do not attempt to stand or walk on spray booth roof. NOTICE
Refer to exploded view drawings included with your spray booth. 1. Starting with exhaust chamber at either rear corner, bolt one corner panel and one rear wall corner panel together (use tie channel where applicable). 2. Bolt opposite rear sidewall panel to rear wall panel. 3. Bolt all rear wall panels in place.
CHAMBER SIDE PANEL
4. Bolt tie channel along top edge of rear wall panels. 5. Place exhaust fan panel above side and rear wall panels and bolt in place. 6. Insert filter filler panels between sidewall, roof panels and exhaust chamber. Bolt in place. 7. Following exploded view drawings, continue alternately assembling wall panels and roof panels to each other until you reach front end of booth. Finish off roof section by attaching fire curtain if needed. If booth has front doors, no fire curtain is needed.
FILTER FILLER PANEL
BOOTH SIDE PANEL
17
Made with FlippingBook - professional solution for displaying marketing and sales documents online