8. Verify walls are plumb and booth is square and on floor layout marks. Tighten all mounting hardware. 9. Anchor floor channel to floor at a minimum of every 12 inches. 10. Caulk all panel joints inside the booth with the caulk provided. Do not use a silicone caulk. 11. If booth is supplied with a personnel door or product doors, apply gasket to perimeter of all door openings. Attach door hardware and adjust latches. Level door with doors off, then attach doors to hinges.
DOOR LATCH AND SEAL DETAIL
DOOR FRAME BASE DETAIL
PRODUCT DOOR DOOR SWEEP DETAIL
12.Other
tallation that may apply to your type of booth
USE 3/8" HARDWARE TO ASSEMBLE @ EACH 5-HOLE PATTERN (NUT & BOLT)
USE 1/2" HARDWARE TO ASSEMBLE ITEMS PICTURED (BOLT, NUT & LOCK WASHERS
FOR OPTIMAL DOOR SEAL APPLY 3/4" GASKET TO THIS SURFACE
USE 1/2" HARDWARE TO ASSEMBLE ITEMS PICTURED (BOLT, NUT & LOCK WASHERS
INSTALL PANEL STIFFENERS ON THE OUTSIDE OF CEILING PANEL JUNCTION AS SHOWN DO NOT INSTALL IN BETWEEN
18
Made with FlippingBook - professional solution for displaying marketing and sales documents online