4.10 Tubeaxial Fan
WARNING
Fan assembly is heavy. Fan assembly weight is approximately 50 - 200 lbs., depending on model. Use an adequate lifting device to install fan assembly.
WARNING
Prevent serious injury or death. Electrical installations must be performed by qualified electricians. Installation must conform to all national, local, and provincial codes and standards.
The fan and motor assembly will bolt to fan panel. 4.11 Exhaust Duct Installation If equipped with optional exhaust ductwork, it is recommended to have this professionally installed. To assemble ductwork: 1. Bolt pipe with connecting ring to the exhaust fan. 2. Remaining ductwork is crimped on one end to interlock
with the next section. Crimped ends of duct shall be installed with the crimped edge pointed inward in the direction of airflow. 3. Your ARV (automatic roof ventilator) will be mounted on top. 4. Storm collar will attach to duct above flashing to make it weather proof. Where more than 25 ft. of piping is required, static pressure (resistance) is increased and the airflow may be hindered when using the standard exhaust unit recommended for use with the booth. Where a piping arrangement of an unusual nature is necessary or where two or more elbows are used, a similar condition may exist. Therefore, if either of these situations arises, contact RTT for recommendations.
26
Made with FlippingBook - professional solution for displaying marketing and sales documents online