DF 500 – set any mortise height The dimension shown on the fence height gauge is the distance from the center of the mortise to the underside of the fence. Release the fence height locking lever and raise the fence using the auxiliary handle. Then push the board thickness guage towards the back of the machine until it stops. Set the required mortise height on the scale by moving the fence up or down to the required height. Now tighten the fence height locking lever.
DF 500
DF 700
DF 700
DF 700 The mortise height on the DF700 is set in the same way other than how the measurements on the step gauge are labeled. The height step gauge on the DF 700 does not designate the board thickness, but instead it is the actual distance from the center of the mortise to the underside of the fence.
NOTE The alignment of the clamping levers can be adjusted by pulling them away from the fence and re-indexing them so that when they are in the locked position they do not go past the fence itself.
22
Made with FlippingBook - Online catalogs