1
2
Set the mortise depth to 25 mm – set the limit stops to 25 mm and 50 mm.
It is a good idea to work with the locating pins in this case. Select the pins depending on the desired mortise placement. Ensure that the mortise for the corner connector has a minimum distance of 37 mm from the edge of the workpiece. If you work with the locating pins use the middle pin for 37mm from the edge.
3
Route the mortises in the table or bedpost (narrow mortise width) with a mortise depth of 25 mm. Set one mortise for the expansion bolt of the corner connector, the others for alignment of the work piece from the standard Domino tenons.
60
Made with FlippingBook - Online catalogs