Complete booth assembly and then perform steps 1-5 below to connect electrical service to motor.
1. Determine voltage at your facility. RTT does not recommend using 120V single phase on motors above 1HP. 2. If a control panel or motor starter was ordered with this booth, confirm that the voltage and phase on the control panel matches the voltage and phase you intend to use. 3. Locate the wiring diagram above that matches your voltage, phase, and HP. 4. Some motors may have 2 additional red wires. These wires are for an internal thermal overload. We do not use these wires and they should be capped off with wire nuts or electrical tape. 5. Locate the rotation arrow on the fan and verify belts are rotating in the direction of the arrow. If the belts are not rotating in the direction of the arrow, reverse the motor.
3/4 - 1.5 Hp 120 V Single Phase (Wire for "Low Voltage")
3/4 - 3 Hp 230V Single Phase (Wire for "High Voltage")
To reduce the risk of electric shock, the motor is to be grounded per local electrical code.
T5
T1
T3
T3
To reduce the risk of electric shock, the motor is to be grounded per local electrical code.
T2
T5
L1 120VAC Hot
T2
T1
To reverse the motor Swap 5 and 8 Incoming 1PH power from control panel, motor starter.
L1
T4
T4
L2 120VAC Neutral
T8
T8
L2
To reverse the motor Swap 5 and 8 Incoming 1PH power from control panel, motor starter.
To reverse the motor Swap T5 and T8
To reverse the motor Swap T5 and T8
5 Hp 230V Single Phase (Wire for "High Voltage")
208 thru 240V Three Phase (Wire for "Low Voltage")
To reduce the risk of electric shock, the motor is to be grounded per local electrical code.
To reduce the risk of electric shock, the motor is to be grounded per local electrical code.
T1
L1
T8
T7
T2
T1
T8
L1
T4
L2
T5
To reverse the motor Swap L1 and L2 Incoming 3PH power from control panel, motor starter, or VFD.
T3
T5 T4
T9
T6
L2
To reverse the motor Swap 5 and 8 Incoming 1PH power from control panel, motor starter.
L3
To reverse the motor Swap T5 and T8
440 thru 480V Three Phase (Wire for "High Voltage")
L1
T1
To reverse the motor Swap L1 and L2 Incoming 3PH power from control panel, motor starter, or VFD.
T2
L2
T3
T4
L3
T7
T5
T9
T6
To reduce the risk of electric shock, the motor is to be grounded per local electrical code.
T8
Made with FlippingBook - professional solution for displaying marketing and sales documents online