56 UNLOADING
GATE STOPS
All Bullet trailers built after March 2010 are equipped with gate stops. These stops are designed to limit gate opening for windrow unloading and to prevent gate closure during maintenance. To use gate stops for windrow unloading: 1. Remove the Lock Pin and cotter pin from the pin holder bracket near the Lower Rail on the curb side. The Gate Stop on the driver’s side is not used. 2. Align the holes in the slider with the desired hole in the adjustment bar NOTE: The lower the hole is located on the adjustment bar, the less the gates will open. 3. Insert the Lock Pin through the slider and adjustment bar. 4. Secure the Lock Pin with the cotter pin.
LOCK PIN STOWED IN BRACKET
GATE STOP SET
GATE STOP LIMITS GATE OPENING
PIN HOLDER BRACKET To use gate stops for maintenance, refer to the Gate Lockout Procedure in this manual. Use only original gate stop equipment. SLIDER
Made with FlippingBook Annual report maker